1. The machine cannot start and operate normally?
Check whether the power supply and safety switch are fully turned on.
2. The e-knife does not cut?
Check whether the induction eye is damaged and whether the electronic knife switch is open.
3. The book desk doesn't work?
Check whether the jack is in good contact and whether the speed adjusting switch of the book receiving table is opened at the minimum.
4. Is the paper table uneven?
Check that the chain of lifting platform is adjusted to the same plane.
Common exception elimination methods:
1. Paper skew:
(1) conveyor belt elastic, belt interface is not flat or broken
(2) the paper bump knife or bump pull gauge, paper such as found when the paper uneven, can be kneaded in advance, so as not to lose paper skew.
2. No deviation or deviation:
(1) the paper ball did not completely press the paper, paper rebound phenomenon, resulting in inaccurate positioning;
(2) cots pressure uneven;
(3) knife is not sharp or improper installation.
3. Paper transfer congestion?
(1) the paper is not completely into the fold plate or roll Angle phenomenon;
(2) transmission belt is not flat or broken;
(3) folding knife down position is not enough, folding roller pressure too loose.
4. Bad suction?
Check the size of suction and whether there is any damage to the nozzle piece.
5. Rub the rubber roller when the electronic knife is cut?
Electronic knife should be corrected in the middle of the gap between two folding cots, electronic knife drop too deep.
Equipment repair and maintenance:
Should be strictly in accordance with the company's equipment daily maintenance, maintenance, maintenance of the articles of association to carry out, strictly prohibit the equipment to knock, hit, hit, seriously do a good job in equipment maintenance work.